Pride Mobility QUANTUM JAZZY 1420 Owner's Manual page 22

To install the seat:
1. Set the trapeze bars to the desired height. To change the
trapeze bar height, see V. "Comfort Adjustments."
2. Tilt the seat back and slide the rear extrusion onto the
rear trapeze bar. See figure 10.
3. Lower the front extrusion onto the front trapeze bar
until the seat locks into place.
4. Flip the seat latch safety down.
WARNING! Make sure the seat latch safety
is flipped down before using your power
chair.
Power Elevating Seat Installation (Optional)
Your power chair may be equipped with the power
elevating seat option. While the seat itself may be any one
of the styles offered for this model, the way the seat base
attaches to the power base is different.
To install the power seat:
l. Align the seat shaft to the hole in the actuator. See
figure 11.
2. Insert the seat shaft into the actuator and push the seat
lever forward.
3. Secure the seat into place.
4. Plug the power elevating seat switch cable into the
connector on the electronics tray.
Controller Installation
Depending on the various configurations and options you
have chosen for your power chair, it may have been
shipped without the controller module installed in the
armrest.
MANDATORY! Prevent controller harness
damage! Avoid
harness on the outside of the armrest pad.
Route the harness under the armrest or
toward the inside of the armrest pad. Use
correct tie-down points for the controller
harness to prevent the harness from
getting caught in the drive tyres, pinched
in the seat frame or damaged when
passing through doorways.
1. Flip up either the right or left armrest.
2. On a contour seat, flip up the armrest and loosen the
setscrew. See figure 12. On the standard seat, loosen the
setscrews in the mounting block. See figure 20.
3. Slide the controller into the armrest.
4. Tighten the setscrew(s) and lower the armrest.
5. Route the controller harness so that it cannot be pinched
in the seat hinge and secure the controller harness with
wire ties. See figure 13.
6. Remove the rear lid to expose the electronics tray.
7. Plug the controller connector into the electronics tray.
See figure 6.
8. Secure the controller harness to the armrest receiver
with one or more wire ties.
22
I V . A S S E M B L Y
routing the controller
www.pridemobility.com
Figure 11. Power Elevating Seat Actuator
Figure 12. Controller Installation (Underside of
Armrest)
Figure 13. Controller Harness Routing on a Contour
Seat
SETSCREW
WIRE TIES
Quantum Jazzy 1420