Seat Position Adjustment - Pride Mobility QUANTUM JAZZY 1420 Owner's Manual

V . C O M F O R T A D J U S T M E N T S
13. Reinstall the trapeze bars and secure with the quick-release pins.
14. Reinstall the seat.
NOTE: Make sure the seat latch safety is flipped down before using
the power chair seat.
15. Plug the controller connector(s) into the electronics tray.
16 Secure the controller harness to the armrest receiver with one or
more wire ties. See figure 13.

Seat Position Adjustment

You can move the seat forward or rearward by changing the extru-
sion mounting position.
To change the seat position:
1. Turn off the power to the controller.
2. Unplug the controller connector(s) from the electronics tray.
3. Remove the seat from the power base.
4. Remove both extrusions from the bottom of the seat.
5. Reposition the extrusions on a different set of mounting holes.
You must move both extrusions the same number of holes either
forward or rearward. See figure 16.
6. Fasten the extrusions back onto the bottom of the seat.
7. Reinstall the seat.
8. Plug the controller connector(s) into the electronics tray.
Reclining Seat Adjustment (Optional)
If your power chair is equipped with a reclining seat, you can adjust
the seatback angle with the seatback release lever. The lever is
located on the right side of the seat base.
To adjust the seatback angle:
1. Pull up on the seatback release lever.
2. Move the seatback down or up to the desired position.
3. Release the lever.
High-Back with Headrest Adjustment (Optional)
If your power chair is equipped with the deluxe high-back seat, you
can adjust the headrest height.
To adjust the headrest height:
1. Push in the headrest release button.
2. Move the headrest up or down to the desired position.
24
www.pridemobility.com
SEAT MOUNTING HOLES
Figure 16. Seat Position Adjustment
Quantum Jazzy 1420