Seat Installation - Pride Mobility QUANTUM JAZZY 1420 Owner's Manual

SEAT INSTALLATION

It may be necessary to install the seat either prior to initial operation or after transporting your power chair. Most
seats are attached to the power base with the Universal Mounting System (UMS). The UMS consists of universal
parts that may be attached to any high-back seat, regardless of seat width or seat depth. The two main components
are aluminum extrusions mounted to the seat base. These extrusions attach to a pair of trapeze bars that are
mounted to the power base. See figure 10. If your power chair is equipped with a Synergy Seat or a TRU-Balance
Power Positioning System, refer to the information provided in separate manuals.
WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may
lose control of the seat if they do so.
NOTE: Any nylon insert lock nut removed during the disassembly or adjustment of the power chair must be
replaced with a new nut. Nylon insert lock nuts should not be reused as it may cause damage to the nylon insert,
resulting in a less secure fit. Replacement nylon insert lock nuts are available at local hardware stores or
through your Quantum Rehab Dealer.
Figure 10. Seat Installation
Quantum Jazzy 1420
I V . A S S E M B L Y
REAR EXTRUSION
FRONT EXTRUSION
www.pridemobility.com
SEAT LATCH SAFETY
REAR TRAPEZE BAR
FRONT TRAPEZE BAR
21