Controller Position - Pride Mobility Jazzy Elite ES Owner's Manual

V . C O M F O R T A D J U S T M E N T S

Controller Position

You can move the controller in toward or out away
from the armrest, or change the position of the control-
ler for either left-hand or right-hand use.
WARNING! Do not place the controller
harness so that it can be pinched in
the seat frame or the power base
frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the
floor.
2. Loosen the setscrew on the controller bracket. See
figure 13.
3. Slide the controller into or out of the armrest to the
desired position.
4. Tighten the setscrew to secure the controller.
To change the controller position:
1. Turn off the power to the controller.
2. Unplug the controller harness from the power base.
3. Cut the wire tie(s) that secure the controller harness
to the armrest and seat.
4. Flip up the armrest so it is perpendicular to the
floor.
5. Loosen the setscrew on the controller bracket. See
figure 13.
6. Slide the controller out of the armrest.
7. Loosen the setscrew in the other armrest.
8. Place the controller in the other armrest.
9. Tighten the setscrew to secure the controller.
10. Route the controller harness along the seat frame
and secure with wire ties. See figure 8.
11. Plug the controller connector into the power base.
See figure 2.
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform. See
figure 14.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the adjustment
screw.
2. Turn the adjustment screw to raise or lower the
front of the foot platform.
Jazzy Elite ES Series
Figure 13. Underside of Armrest
Figure 14. Foot Platform Angle Adjustment
www.pridemobility.com
FOOT PLATFORM
BRACKET
ADJUSTMENT SCREW
SETSCREW
HARDWARE
17