Tiller Angle Adjustment; Seat Height Adjustment - Pride Mobility Victory XL-8 Owner's Manual

V I I . C O M F O R T
WARNING! Remove the key from the key switch before adjusting the tiller or the seat. Never
attempt to adjust the tiller or the seat while the scooter is in motion.

TILLER ANGLE ADJUSTMENT

You can adjust the tiller to many positions. The tiller adjustment lever locks the tiller in place; it has a spring-loaded
mechanism that enables you to rotate it and change its position.
1. Turn the tiller adjustment lever counterclockwise until it is loose. If the tiller adjustment lever comes in contact
with the tiller basket, pull it outward, turn it clockwise, and release it. Continue to loosen until you are able to
move the tiller. See figure 8.
2. Squeeze the release buttons (located beneath the tiller boot) and move the tiller to a comfortable position.
3. Turn the tiller adjustment lever clockwise until it is tight. If the tiller adjustment lever comes in contact with the
tiller basket, pull it outward, turn it counterclockwise, and release it. Continue to turn the lever until it is tight.
The tiller may be lowered to the center of the floorboard and locked in place for storage. See VIII. “Disassembly
and Assembly.”

SEAT HEIGHT ADJUSTMENT

The seat can be repositioned to one of three different heights.
1. Remove the seat from your Victory XL-8. See VIII. “Disassembly and Assembly.”
2. Use the attached ring to pull and remove the ball detent pin from the seat pedestal. See figure 9.
3. Raise or lower the seat post tower to the desired seat height.
4. Hold the seat post tower at that height and match up the holes in the seat post tower with the seat pedestal.
5. Fully insert the ball detent pin.
6. Replace the seat.
NOTE: The supplied nut, bolt, and washers can be used as an alternate to the ball detent pin for seat
height adjustment and stability.
SQUEEZE THE RELEASE BUTTONS
Figure 8. Tiller Angle Adjustment
24
A D J U S T M E N T S
TILLER BOOT
SEAT PEDESTAL
TILLER
ADJUSTMENT LEVER
Figure 9. Seat Height Adjustment
BALL DETENT PIN
SEAT POST TOWER
Victory XL-8