Injector - Removal And Installation - MTU 8 V 2000 M84 Operating Instructions Manual

7.6.2 Injector – Removal and installation
Preconditions
☑ Engine is stopped and starting disabled.
Special tools, Material, Spare parts
Designation / Use
Socket wrench
Puller
Double box wrench
Open end wrench bit
Box wrench adapter
Alignment device
Grease (Kluthe Hakuform 30-10/Emulgier)
Engine oil
WARNING
Fuels are combustible.
Risk of fire and explosion!
• Avoid open flames, electrical sparks and ignition sources.
• Do not smoke.
Preparatory steps
1. Close fuel supply to engine.
2. Remove cylinder head cover (→ Page 78).
Removing injector
1. Remove HP line (5) using socket wrench.
2. Disconnect injector cable (4).
3. Remove screw (2).
4. Take off hold-down clamp (3).
5. Remove injector (1) with puller.
6. Remove O-rings from injector.
7. Mask all connections and bores or seal with
suitable plugs.
80 | Task Description | MS150062/01E 2012-01
Part No. Qty.
0005896803/00
F6790629
F30011450
F30025897
F30451199
F6790507
X00029933
1
1
1
1
1
1
1