Table of Contents
Advertisement
Operation
Program function
Cycle
Turbo
Water Level
Temp
Auto
Auto
Min
Cold
●
Whites
Med
Warm
Max
Hot
Auto
Auto
Min
Cold
●
Jeans
Med
Warm
Max
Hot
Auto
Auto
Min
Cold
●
Active Wear
Med
Warm
Max
Hot
Auto
Auto
Min
Cold
●
Heavy Duty
Med
Warm
Max
Hot
Auto
Min
Colors
●
Cold
Med
Max
Drain&Spin
Auto
Cold
Tub Clean
Max
Warm
Hot
Auto
Min
Rinse&Spin
Cold
Med
Max
Auto
Min
●
Delicates
Cold
Med
Max
Auto
Auto
Min
Cold
Only Wash
●
Med
Warm
Max
Hot
Auto
Cold
Quick Wash
Med
Warm
Hot
Auto
Auto
Min
Cold
ECO Normal Wash
Med
Warm
Max
Hot
When you turn to one option which there is no beep notice. It means the function
can not be selected with this program.
Spin Level
Pre Soak
Fabirc Softener
Extra Rinse
Auto
Low
●
●
Normal
Max
Auto
Low
●
●
Normal
Max
Auto
Low
●
●
Normal
Max
Auto
Low
●
●
Normal
Max
Auto
Low
●
●
Normal
Max
Max
Low
Auto
Low
Normal
Max
Auto
Low
●
●
Normal
Max
Normal
Auto
Low
●
Normal
Max
21
Maintenance
Cleaning the exterior
Turn off the water faucets after final use.
This will shut off the water supply to your washer and prevent the unlikely possibility of
damage from escaping water. Leave the lid open to allow the inside of your washer to dry
out.
Use a soft cloth to wipe up all detergent, bleach or other spills as they occur.
Clean the following as recommended:
Control Panel - Clean with a soft, damp cloth. Do not use abrasive powders or
cleaning
pads. Do not spray cleaners directly on the panel.
Cleaning the interior
Clean the interior of your washer periodically to remove any dirt, soil, odor, mold, mildew,
or bacterial residue that may remain in your washer as a result of washing clothes.
Failure to follow these instructions may result in unpleasant conditions, including odors
and/or permanent stains on your washer or laundry.
Hard water deposits may be removed, if needed. Use cleaners labeled "Washer safe".
Cleaning the detergent, bleach, softener compartments
You may find laundry product residue leftover in your compartments. To remove residue,
wipe with a damp cloth and towel dry. Do not attempt to remove the compartments or
trims for cleaning. The compartments and trims are not removable.
Storing your washer
Washers can be damaged if water is not removed from hoses and internal components
before storage.
Preparing your washer for storage as follows:
- Select the Quick wash cycle and add bleach to the washer. Run your washer through
the cycle without a load.
- Turn the water faucets off and disconnect the inlet hoses.
- Unplug your washer from the electrical outlet and leave your washer lid open to let air
circulate inside the drum.
- If your washer has been stored in below-freezing temperatures, allow time for any
leftover water in your washer to thaw out before use.
Tub clean
Tub clean is a self-cleaning cycle that removes mold that may occur
inside the washer.
1. Select the
Tub clean
- Once the
Tub clean
automatically cancelled
2. Press the
Start/Pause
- If you press the
Using Tub clean, you can clean the tub and drum without using a
cleansing agent.
Never use Tub clean cycle when laundry is in the washer.
This may cause damage to the laundry or a problem with the
CAUTION
washer.
on Cycle selector.
is selected, the other
function will be
.
button.
Start/Pause
button, Tub clean begins.
22
Advertisement
Table of Contents
