Creati Ng A Goto Route - Magellan eXplorist Basic User Manual

45
Creating a GOlO Route
The instructions here describe the most common and easiest way to create a GOTO
route.
With the POI highlighted, press ENTER.
If you already have a Gala you will be asked to
confirm the creation of this GOTO.
Note: Detailed instructions for searching the POI
I~~
database can be found in the Points of Interest section
1
of this manual.
i
~Ot
;,,):\:::::::::,'!imE'
Press GOTO.
Use the POI database to select the POI to be the
desti nation.
1.
2.
3.
4.
Map screen with a GOTO
route active. Notice the
After you press ENTER, the last viewed navigation screen will be
line on the screen that
displayed, updated as needed to provide information about the
graphically displays the
GOTO route you have created. On the Map screen, a line will be
route.
drawn representi ng the GOTO route. The Compass screen wi II
change to display the name of the POI used as the destination in the screen header
bar and an icon representing the destination outside the diameter of the compass.
As you are moving you will notice a second line appearing that points to your
destination if you go off the planned course. The double solid line is the original,
computed route. The new, dashed line is an updated route, pointing towards your
destination. So even if you can't follow the computed route, you will be updated with
a new course to follow. This updating of your route will also occur during multi-leg
routes so you always know which way you need to go.