Swing Arm Replacement - Vision Fitness S70-02 Service Manual

5.18 Swing Arm Replacement

1) Remove the incline arm cover as outlined in Section 5.17.
2) Remove the bolt from the upper pivot joint of the vertical stabilizer arm (Figure A).
3) Remove the plastic cap from the swing arm (Figure B).
FIGURE A
4) Remove the bolt that holds the pedal and swing arms together (Figure C).
5) Take the bolt removed in Step 2 and turn it into the shaft, then use a mallet to hit the head of the bolt until the swing arm can be separate from the pedal
arm (Figures D & E).
FIGURE C
6) Remove the swing arm (Figure F).
FIGURE E
7) Reverse Steps 1-6 to install a new swing arm. NOTE: Torque the bolt removed in Step 4 to 80 N-m when installing a new swing arm.
8) Test Elliptical for function as outlined in Section 5.22.
CHAPTER 5: PART REPLACEMENT GUIDE
FIGURE B
FIGURE D
FIGURE F
44