Console Replacement - Vision Fitness S70-02 Service Manual

CHAPTER 5: PART REPLACEMENT GUIDE

5.10 Console Replacement

1) Remove the 2 screws holding the cup holder to the console and remove the cup holder (Figure A). NOTE: There may be plastic caps present over the
screws.
2) Remove the 4 screws holding the top back cover to the console.
3) Disconnect the console cable and HR connections from the defective console and remove the console (Figure B).
FIGURE A FIGURE B
4) Remove the 4 screws exposed when the cup holder is removed (Figure C). Carefully pull the wiring out the bottom of the console and remove it.
FIGURE C
5) Reinstall the wire connections to the new console.
6) Carefully push the wires into the console and mast until they are clear of the console / mast connection and attach the console to the mast using the 4
screws.
7) Test the Elliptical for function as outlined in Section 5.22.
34