Pulley Axle Set Replacement - Vision Fitness S70-02 Service Manual

5.7 Pulley Axle Set Replacement

1) Remove the shrouds as outlined in Section 5.1.
2) Loosen the belt tension bolt on the right side until there is enough slack to remove the drive belt (Figure A).
3) On the right side of the frame, remove the retaining clip that holds the pulley axle bearing into the frame (Figure B).
FIGURE A
4) On the left side of the frame, remove the retaining ring that holds the pulley axle bearing into the frame (Figure C).
5) Remove the pulley axle set assembly from the frame. Clean any debris from the hole in the frame (Figure D).
FIGURE C
6) Reverse Steps 1-5 to install a new pulley axle set. Rotate the pulley to make sure that the motion is smooth and that there is no wobbling to one side.
Re-install the belts as outlined in Sections 5.5 and 5.6. NOTE: The idler bolt removed in Step 2 should be torqued to 80 N-m.
7) Test the Elliptical for function as outlined in Section 5.22.
CHAPTER 5: PART REPLACEMENT GUIDE
FIGURE B
FIGURE D
28