Address Setup (Manual Setting From Remote Controller) - Toshiba RAV-SM564UTP-E Service Manual

9-3. Address Setup (Manual Setting from Remote Controller)

In case that addresses of the indoor units will be
determined prior to piping work after wiring work
• Set an indoor unit per a remote controller.
• Turn on power supply.
1
SET CL
Push +
simultaneously for 4 seconds or more.
2
(Line address)
Using the temperature setup
set 12 to the CODE No.
3
Using timer time
4
SET
Push button. (OK when display goes on.)
5
(Indoor unit address)
Using the temperature setup
6
Using timer time
7
SET
Push button. (OK when display goes on.)
8
(Group address)
Using the temperature setup
9
Using timer time
Folloer unit.
10
SET
Push button. (OK when display goes on.)
11
TEST
Push button.
Setup completes. (The status returns to the usual stop status.)
<Operation procedure>
1
SVM-13010_051-106.indd 86 SVM-13010_051-106.indd 86
Indoor unit address → 1
TEST
+ buttons
/
/ buttons, set the line address.
/
/ buttons, set 1 to the line address.
/
/ buttons, set
TEMP.
2, 5, 8
11
END
FILTER L L
RESET
1
2 3 4 5
(Example of 2-lines wiring)
(Real line: Wiring, Broken line: Refrigerant pipe)
Outdoor
1 2 3
1 2 3
Indoor
A B
Line address → 1
Group address → 1
A B
Remote controller
For the above example, perform setting by
buttons, connecting singly the wired remote controller
without remote controller inter-unit wire.
Group address
Individual
Header unit : 0001
Follower unit : 0002
buttons, set to the CODE No.
buttons, set to the CODE No.
to Individual, to Header unit, and
ON / OFF
TIMER SET FAN MODE
TIME SAVE A A VENT
TEST SET CL SWING/FIX UNIT LOUVER T
6 7 8 9
– 86 –
FILE NO. SVM-13010
Outdoor
1 2 3
1 2 3
1 2 3 1 2 3
Indoor Indoor Indoor
A B A B
A B
1 2
1
2 1
3
2
2
2
: 0000
In case of group control
3, 6, 9
4, 7, 10
10 11
END
1 2 3
Indoor
A B
2
2
2
to
2/1/13 2:49 PM 2/1/13 2:49 PM