Error Messages - Muratec MFX-C3035 User Manual

Error messages

If a machine malfunction occurs, the error screen appears with one of the fol-
lowing error messages. Refer to the following table, and then perform the
indicated operation.
If fax transmissions/receptions still cannot be performed correctly, even after
performing the described operations, contact your technical representative.
Error message
[Off-Hook]
[Memory Full (Fax)]
[Fax TX Failed]
[Fax RX Failed]
[PC-Fax TX Error]
[Polling RX Error]
[PC-Fax Restricted]
[I-Fax TX failed]
Error messages
Cause
The machine has been
left off-hook after a man-
ual transmission.
The memory is full.
An error occurred while
a G3 fax is being sent.
An error occurred while
a G3 fax is being
received.
An error occurred while
receiving PC-Fax TX
data.
Multiple destinations
were specified for polling
reception.
A PC fax transmission
was requested although
PC fax transmissions
are prohibited.
An error occurred while
an Internet fax is being
sent.
Solution
Put the machine back
on-hook.
If a fax is being sent,
send the scanned docu-
ment pages. Otherwise,
send the fax manually.
If a fax is being received,
print the received docu-
ments saved in the
memory.
This error is automati-
cally cleared.
This error is automati-
cally cleared.
This error is automati-
cally cleared.
Multiple destinations
cannot be specified for
polling reception. Try
performing the opera-
tion again with only one
destination specified.
For details on specifying
PC fax transmission set-
tings, refer to "[Fax
Function Settings]" on
page 2-13.
This error is automati-
cally cleared.
8-9