Muratec MFX-C3035 User Manual page 124

Symptom
Transmission is not pos-
sible.
Problems when sending faxes
Cause
The transmission proce-
dure may have been
performed incorrectly.
The fax number may be
wrong.
The address book desti-
nation, group destination
or program destination
may have been regis-
tered incorrectly.
The telephone line may
be incorrectly con-
nected.
There may be a problem
with the recipient's fax
machine (such as, no
paper or turned off).
An incorrect telephone
line setting may have
been selected.
An incorrect password
may have been speci-
fied when the transmis-
sion was sent with
[Password TX] set to
[Yes].
An incorrect password
may have been speci-
fied when the transmis-
sion was sent with
[F-Code TX] set to [Yes].
The recipient's fax num-
ber may have been
incorrectly specified on
their fax machine when
the transmission was
sent with [TX Confirm
CSI] set to [Yes].
Solution
Check the transmission
procedure, and then try
sending the fax again.
Check the fax number.
Check that the destina-
tions were correctly reg-
istered.
Check the telephone line
connection. If it is dis-
connected, connect it.
Contact the recipient.
Check that the dialing
method setting selected
from the [Comm. Set-
tings] screen matches
the telephone line being
used.
Check the password at
the receiving end, and
then try sending the fax
again with the correct
password.
Check the password at
the receiving end, and
then try sending the fax
again with the correct
password.
Have the recipient check
that their fax number is
correctly specified on
their machine.
8-3