The Font Cannot Be Printed; Printing In The Postscript 3 Mode Problems; The Printer Does Not Print Correctly In The Postscript Mode; The Printer Does Not Print - Epson AL-C300 Series User Manual

AL-C300 Series User's Guide
Cause
The emulation setting for the port may not be correct.
Note:
If a configuration status sheet does not print correctly, your printer may be damaged. Contact your dealer or a qualified service
representative.

The font cannot be printed

Cause
For Windows users, you may use the printer fonts
substituted for specified TrueType fonts.
The selected font is not supported by your printer.

Printing in the PostScript 3 Mode Problems

The problems listed in this section are those that you may encounter when printing with the PostScript driver. All
procedural instructions refer to the PostScript printer driver.

The printer does not print correctly in the PostScript mode

Cause
The printer's emulation mode setting is incorrect.
The printer's emulation mode setting for the interface
that you are using is incorrect.

The printer does not print

Cause
An incorrect printer driver is selected.
Troubleshooting
What to do
Specify the emulation mode by using the printer's control panel
menus. See "Emulation Menu" on page
What to do
In the printer driver, choose the Print TrueType fonts as bitmap
check box in the Extended Settings dialog box.
Make sure that you have installed the correct font. See the Font Guide
for more information.
What to do
The printer is set to the Auto mode by default, so that it can
automatically determine the encoding used in the received print job
data and select the appropriate emulation mode. However, there are
situations where the printer cannot select the correct emulation
mode. In this case, it must be set manually to PS3.
Set the emulation mode through the SelecType Emulation Menu
on the printer. See "Emulation Menu" on page
The emulation mode can be set individually for each interface which
receives print job data. Set the emulation mode for the interface you
are using to PS3.
Set the emulation mode through the SelecType Emulation Menu
on the printer. See "Emulation Menu" on page
What to do
Make sure that the PostScript printer driver that you are using to
print is selected.
75
28.
28.
28.