Lenovo ThinkCentre M73z Hardware Maintenance Manual page 90

5. Remove the hard-disk-drive EMI shield. See "Removing and installing the hard-disk-drive EMI shield"
on page 79.
6. Disconnect the cable from the solid-state drive.
7. Remove the screw
remove it from the chassis.
Figure 18. Removing the hard-disk-drive bracket with the solid-state drive
8. Remove the three screws that secure the solid-state drive to the bracket, and then remove the
solid-state drive from the bracket. Do not touch the circuit board on the bottom of the solid-state drive.
Figure 19. Removing the solid-state drive from the bracket
9. To install the new solid-state drive, position the new solid-state drive in the hard-disk-drive bracket so
that the three screw holes in the solid-state drive align with the corresponding holes in the bracket.
Then, install the three screws to secure the solid-state drive to the bracket.
10. Position the bracket with the new solid-state drive in the chassis so that the screw hole in the bracket
aligns with the corresponding hole in the chassis. Then, install the screw to secure the bracket with the
solid-state drive to the chassis.
84
ThinkCentre M73z Hardware Maintenance Manual
1 , and then pivot the hard-disk-drive bracket with the solid-state drive as shown to