Removing And Installing The U-Shaped Stand - Lenovo ThinkCentre M73z Hardware Maintenance Manual

CAUTION:
Before you open the computer cover, turn off the computer and wait several minutes until the
computer is cool.
To remove the computer cover, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer stand. See "Removing and installing the computer stand" on page 73.
4. Loosen the two screws
it from the computer.
Figure 10. Removing the computer cover

Removing and installing the U-shaped stand

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Safety information" on page 1.
This section provides instructions on how to remove and install the U-shaped stand.
Note: The U-shaped stand is available only on computers that are equipped with a frame stand.
To remove and install the U-shaped stand, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer stand. See "Removing and installing the computer stand" on page 73.
4. Remove the computer cover. See "Removing the computer cover" on page 76.
1 at the bottom of the computer, and then lift the computer cover up to remove
.
Chapter 8 Replacing FRUs
77