Bow/Stern Eyelets; Mooring Cleats; Cup Holders; Swim Platform - Sea-doo Challenger*180 Operator's Manual

35) Bow/Stern Eyelets

Eyelets can be used for mooring, tow-
ing and as a tie-down point during
transportation.
1
F23L0UY
TYPICAL
1. Bow eyelet
2. Stern eyelet

36) Mooring Cleats

When mooring to a dock, it is recom-
mended to secure the boat with both
front and rear cleats. The use of dock
lines with sealed air fenders is recom-
mended to protect your boat.
CAUTION: Never use mooring cleats
to pull anything or to lift the boat.

37) Cup Holders

Convenient locations for non-alcoholic
beverages.
WARNING
Never operate boat while under the
influence of alcoholic beverages
while aboard. Do not keep bottles,
cans etc. in cup holders while riding
at high speed and/or on rough water.

38) Swim Platform

Provides an anti-skid surface for easy
boarding from rear of the boat.
WARNING
Do not start or operate the boat if a
person is seated on the platform. En-
gine must be off when using swim
platform. Keep away from jet or in-
take grate.
54

39) Engine Cover

Pull upwards on the latch below the
rear center seat cushion and lift engine
cover lid.
1
2
F23L0VY
1. Engine cover/center cushion
2. Latch
The gas assist cylinders will complete
the opening and hold the cover open.
40) Main Battery Cut-Off
Switch
This switch is located in the port bilge
access compartment. It allows a com-
plete power cut-out of the electrical
system.
When in OFF position, ALL electrical
equipment and electronics will be OFF,
except the bilge pump. The bilge
pump will operate automatically with
the battery switch in the OFF position.
Switch must be in the ON position to
allow the use of electrical components
and to start the engine.
CAUTION: Stop engine before switch-
ing to the OFF position.
2