Antenna Selection - Yaesu FTDX9000D Operation Manual

C
ONVENIENT
Four main antenna jacks, available for both transmission and reception, are provided on the rear panel of the transceiver.
What's more, a receive-only jack is provided, and the incoming signal path may also have a special after-market filter or
preamplifier inserted, if desired, with one-touch access.
Selection of the desired TX/RX antenna is accomplished
by pressing the appropriate 1 ~ 4 Antenna Selection
switch (# ) on the front panel.
To engage the RX-only antenna, press the RX switch
within the Antenna Selection switch group (#
front panel. The RX-only antenna must be connected to
the corresponding "RX ANT" antenna jack on the rear
panel.
The antenna currently selected for use on the Main (VFO-
A) band will be designated by a Red LED.
The antenna currently selected for use on the Sub (VFO-B
band will be designated by an Orange LED.
If both the Main and Sub bands are utilizing the same an-
tenna, both the Red and Orange LEDs will light up on the
same antenna location.
ANT "1"
ANT "2"
ANT "3"
ANT "4"
RX OUT
( MAIN )
BPF
RX ANT
RX OUT
( SUB )
Page 58
F
EATURES

ANTENNA SELECTION

) on the
ANTENNA SWITCH
( VFO-A )
TX/RX RELAY
ANTENNA SWITCH
( VFO-B )
ANTENNA SELECT switch
RX ANTENNA SWITCH
( VFO-A )
RX ANTENNA SWITCH
( VFO-B )
FT 9000D O
DX
Transmitter
Section
MAIN ( VFO-A )
Receiver
SUB ( VFO-B )
Receiver
M
PERATION ANUAL