Subscribe to Our Youtube Channel
Related Manuals for 3M NoisePro Series
Summary of Contents for 3M NoisePro Series
- Page 1 3M Occupational Health and Environmental Safety Division NoisePro Personal Noise Dosimeter ™ ™ NoisePro Series Quick Start Guide...
-
Page 2: Quick Start Steps
Quick Start Steps Turn On 1. Turn on the NoisePro by pressing and releasing key. The display will initialize and sequence to the “START” screen. 2. If “LOBAT” is in display, put new batteries in the NoisePro. Reset 3. Press and hold RESET softkey. The display counts down from 5 then shows “Sessions DELETED”... -
Page 3: View Data
Begin Study 8. Clip the microphone, with windscreen attached to one’s shoulder and secure the NoisePro to the person’s waist. 9. Press key to begin data collection. The run icon will appear in the lower right corner of the display. End Study 10. - Page 4 NoisePro Overview Softkey menus Softkeys (used for additional menu options) Up/Down arrow keys Left/Right arrow keys Enter Escape On/Off Start/Stop studies...
- Page 6 Common Noise Dosimeter Terms Criterion Level (CL) - expressed in decibels (dB), it is the maximum allowable accumulated noise level that results in 100% dose. Regional noise standards specify criterion level. Dose - expressed in percent, it is the percent of the maximum exposure that has accumulated over the run time.
-
Page 7: Pre-Defined Setups
Pre-Defined Setups Six of the nine dosimeter setups are factory-defined and conform to standards established for noise dosimetry in the United States and the European Union. It is recommended to check your regulations prior to data collection. OSHA HC (Hearing Conservation) • “A”... - Page 8 Occupational Health & Environmental Safety Division Quest Technologies, a 3M Company ISO 9001 Registered Company ISO 17025 Accredited Calibration Lab www.questtechnologies.com 1060 Corporate Center Drive Oconomowoc, WI 53066 Please recycle. Printed in USA. Customer Service: 262-567-9157 © 2011 3M Toll Free: 800-245-0779 All rights reserved.
Need help?
Do you have a question about the NoisePro Series and is the answer not in the manual?
Questions and answers