FrameMaker Ver.5.5E(PC) Di151 DIS/REASSEMBLY, ADJUSTMENT
00.03.21
(3)
Removal of the Fusing Roller
1. Gear
2. Fusing Roller
2
Fusing Entrance Guide Plate
NOTES
• When mounting the Fusing Roller, take care not to allow the Paper Separator Fingers to
damage the surface of the roller.
• When installing the gear, make sure that the protrusion on the inner side of the gear fits
into the slit on the end of the Fusing Roller.
• When installing the Fusing Entrance Guide Plate, fit the ground plate of the Fusing
Entrance Guide Plate inside the ground plate on the Fusing Unit side.
Where the Ground Plate is Mounted
Ground Plate of the Fusing
Entrance Guide Plate
Ground Plate of
the Fusing Unit
3
Fusing Roller
D-21
1
Gear
4007D022AA
4007D071AA