SMART Podium 500 User Manual page 5

I M P O R T A N T I N F O R M A T I O N
If you move the interactive pen display, adjust the stand to its full upright position and then
l
use both hands to hold the display unit and the stand separately.
Do not expose your interactive pen display to high voltage electrostatic discharges or to a
l
build-up of electrostatic charge on the screen. This can cause discoloration and blotches on
the screen.
If the interactive pen display is damaged, turn off the display and disconnect the power
l
adapter in order to prevent further damage or personal injury.
C
C A U T I O N – T E T H E R E D P E N
The tethered pen is a sealed unit that contains electronics but no batteries. If you attempt to
l
open the tethered pen, you will damage these electronics. This makes the tethered pen
unusable and voids the warranty.
Do not touch the screen with any instrument other than the tethered pen supplied, because
l
other instruments may damage the screen.
Do not apply excessive pressure that could shorten the life of the tethered pen.
l
Do not immerse the tethered pen in water.
l
C
C A U T I O N – E N V I R O N M E N T
Avoid setting up and using the interactive pen display in an area with excessive levels of
l
dust, humidity and smoke or where it is exposed to direct sunlight, severe temperature
changes, heat from other appliances, water or any other liquid. Operate the interactive pen
display within a temperature range of 5°C to 35°C (41°F to 95°F) and a humidity range of 20%
to 80% (non-condensing). However, you can store the interactive pen display within a
temperature range of -10°C to 60°C (14°F to 140°F) and a humidity range of 20% to 90%
(non-condensing).
Do not modify the power cable. Handle it carefully and avoid bending it excessively. Do not
l
place the power cable in an area where it is likely to be stepped on or pinched by items placed
on or against it. If you must run a cable over the floor, lay it in a flat, straight line and secure it
to the floor with tape or a cable management strip of contrasting colour.
The interactive pen display comes with a three-prong, grounding-type power plug designed to
l
fit into a grounding-type power socket. If you cannot insert the plug into a power socket,
contact an electrician to replace the power socket. Do not modify the power plug.
iii