Pc Connector - Oki MICROLINE 320 Turbo Maintenance Manual

3.3.6 PC Connector

(1) Remove the printhead (see 3.3.1).
(2) Remove the upper cover (see 3.3.4 (1) – (5)).
(3) Remove the gear case Assy (see 3.3.5).
(4) Remove the PC connector
(5) To install, follow the removal steps in the reverse order.
Note on installation:
(1) Do not touch the space motor
dust or foreign matters.
(2) After installation, check and adjust the gap between platen and printhead (see 4-1).
(3) Make sure that there is not any dust or oil on the connector contact section A. If it is
found, wipe it off by alcohol.
42089201TH Rev.4
from the space motor Assy
1
or terminals of PC connector
2
1
(rear side)
2
Oki Data CONFIDENTIAL
.
2
. Also, take care to avoid
1
A
59 /