Lamp Display - Oki MICROLINE 320 Turbo Maintenance Manual

6.3

Lamp Display

(1) Printer mode display
ALARM
ALARM
CATEGORY
Paper end alarm
Paper change
lever alarm
OPERATOR
Paper jam alarm
ALARM
Print Head
thermal alarm
Space motor
thermal alarm
FATAL ALARM
Note:
BLINK1 : 400ms ON, 400ms OFF
BLINK2 : 200ms ON, 200ms OFF
— : LED is kept in Current Condition (no change)
(2) Fault alram display
When the printer detects any of the various alarm states, the information is displayed as
shown below on the operation panel. The alarm is specified by lamp combination of PRINT
QUALITY and CHARACTER PITCH. (See Table 6.3 for details.)
SEL
SEL
MENU SHIFT
Micro Feed
Down
EXIT GROUP
POWER ALARM
42089201TH Rev.4
LED CONDITION
ALARM SEL MENU
ON OFF
ON OFF
ON OFF
BLINK
OFF
1
BLINK
OFF
1
BLINK
OFF OFF
2
LF TEAR
FF/LOAD
Micro Feed
Up
ITEM SET
MENU
Figure 6-1
Table 6.2
CONTENTS
10CPI 15CPI
From, cut sheet or bottom
paper end
Change lever is set to TOP
BLINK position while paper is
OFF
1 already inserted from rear or
bottom.
• Cut sheet could not be
BLINK ejected.
OFF
• Cut sheet could not be fed
1
properly
Print head temperature
°
exceeds 119 C
Temperature of space motor
exceeds specified value.
Hardware Alarm has
See Table 6.3
occurred.
PRINT QUALITY
PARK QUIET
TOF
CHARACTER PITCH
PRINT
RESET
Oki Data CONFIDENTIAL
TROUBLE
SHOOTING
Set New paper.
• Set the lever to specified
position.
• Check rear sensor lever.
• Replace Control Board
• Remove the paper or check
feed Mechanism
• Press SEL key.
• Wait until it is cooled.
• Replace P.H. or Driver
Board
• It is recovered automatically
• Replace SP motor or Driver
Board
See Table 6.3.
HSD UTILITY
NLQ SSD
10 12 15
17 20 PROP
95 /