Preset Positions - Vivotek VS8100 User Manual

VIVOTEK

Preset positions

If you select DynaDome/SmartDOME, Lilin PIH-7x00, or Pelco D, Pelco P protocol, Samsung scc643
protocol protocol as the PTZ driver and click the Save button, the Preset Position button will be enabled.
Click Preset Position to open the settings page. You can also select preset positions for the camera to
patrol. A total of 20 preset positions can be configured.
Please follow the steps below to preset a position:
1. Select Channel in the drop-down list.
2. Adjust the shooting area to the desired position by using the buttons on the right.
position is set as the center position.
3. Enter a name for the preset position, which allows up to forty characters. Click Add to enable the
settings. The preset positions will be displayed under User preset locations.
4. To add additional preset positions, please repeat steps 1~2.
5. Select the preset positions and click on Save to enable the settings.
6. The positions saved will show up in Go to drop down list on the Home page. See next page
7. To remove a preset position from the list, select it and click Remove.
1
3
5
76 - User's Manual
7
The default Home
Functions are the same
as the Control Panel on
the home page
2
6