Vivotek VS8100 User Manual page 6

VIVOTEK
Installation
Please refer to the following illustration for the connection method.
3
2
8
1. Connect the BNC input connector to that on an analogue camera.
2. Connect the DC 12V output to the 12V input on the analogue camera.
3. Connect the DC 12V input to a 12V power source. Normally a 12V 1.5A power adapter will be
sufficient.
4. The Reset button can be used to re-start the video server.
5. If the camera has an embedded microphone, connect a stereo jack to the Audio input.
6. If a camera is mounted on a PTZ scanner, you may connect the RS485 pins for PTZ control.
7. Connect an Ethernet cable to the RJ45 Ethernet port, and connect another end to an Ethernet
switch.
8. See the table below for LED definitions.
9. Visit www.vivotek.com to download the IW2 utility program. Use the IW2 utility to locate and
access your video server.
6 - User's Manual
4 5
RS
6
VS8100
7
1
Analogue camera
DC12V
LAN
9