MISCELLANEOUS OPERATIONS
To change the decompressor assembly
Special tooling required
Decompressor removal/fitting tool P/N 68048
- Remove the cylinder head
- Cut off the end of the pin (1), compress the spring
(2), remove the pin (1) and the lever (3)
- Remove the valve (4) from the decompressor
- Remove the spring (2) from the compressor body
(5)
- Remove the decompressor casing (5) from the
cylinder head
Note: Do not remove the copper seal (6) from the
cylinder head
Page: 40
Reproduction or translation, even partial, forbidden without the written consent of Peugeot Motocycles