Reassembly; To Fit The Bearing And Seal In The Lh Casing - PEUGEOT MOTOR ENGINE Workshop Manual

REASSEMBLY

RE-ASSEMBLY

To fit the bearing and seal in the LH casing

Special tooling required
- Bearing guide and crank assembly seal P/N 69108
- Fitting guide P/N 69110
- Bearing guide and crank assembly seal P/N 69109
Note: the tools and parts should be prepared
before the operation
after heating the casing half, the work must
proceed quite quickly
- Heat the casing half to 80 to 90°C
- Fit the casing half on the guide P/N 69108 with the
mating surface upwards
- Fit the seal guide P/N 69110 (the knurled side facing
upwards) into the bearing bore
- Fit the previously greased seal to guide P/N 69108 (
with the lip facing upwards ) and push it fully home
into the casing half using tool P/N 69109 (small
diameter side) 69109 (small diameter side)
- Remove the fitting tool and seal guide
- Fit the bearing to guide P/N 69108 and push it fully
home into the casing half using tool P/N 69109 (large
diameter side)
Page: 17
Reproduction or translation, even partial, forbidden without the written consent of Peugeot Motocycles