To Fit The Valve And Inlet Manifold; To Fit The Piston - PEUGEOT MOTOR ENGINE Workshop Manual

To fit the valve and inlet manifold

Note: before fitting the valve, check the position of
the 2 stops which must be 8 mm from the valve
support
- Fit in the following order:
- the gasket to the casing (1)
- the valve (2)
- the manifold gasket (3)
- the inlet manifold
- Fit the 4 fixing bolts to the inlet manifold

To fit the piston

- Check the cylinder/piston pairing
- Fit the rings (1) the piston (2)
- Fit the previously greased bearing cage into the
connecting rod little end
- Fit the piston to the connecting rod little end, with
the arrow pointing towards the exhaust side
- Fit the gudgeon pin (3)
- Fit the circlips
Reproduction or translation, even partial, forbidden without the written consent of Peugeot Motocycles
REASSEMBLY
Page: 23