Cornelius FCB Pinnacle Installation Instructions Manual page 7

2 and 4 flavor units

Table of Contents

5. After the charge is removed and pressure has equalized, remove Schrader valve cores (2 each).

6. Use the 90° copper elbow, included in the kit, to carefully mark the tube-cut locations on the drier inlet

and outlet.

7. Use tubing cutter to cut-out filter/drier. Cap both tube openings.

8. Carefully make the tube-cut locations on the hot gas valve outlets at 1-3/8" from the backside of the copper

T, as shown. Cut hot gas valve inlets, 2 each, with imp tubing cutter.

9. Remove insulation on hot gas valve inlet line (if present).

Step 1

Pinnacle Hot Gas Valve Replacement Installation Instructions

Figure 7.

1‐3/8"

Figure 8.

- 5 -

Step 2

Publication Number: 629091023INS

Table of Contents