Installing The Switch; Installing The Wing Strut - Pheonix Model Cessna 182 Instruction Manual

Instruction Manual

INSTALLING THE SWITCH

1. The switch should be mounted on the fuselage
side, opposite the muffler, close enough to the
receiver so the lead will reach. Use the face
plate of the switch cut out and locate the
mounting holes.
2. Cut out the switch hole using a modeling knife.
Use a 2mm drill bit and drill out the two
mounting holes through the fuselage side.
3. Secure the switch in place using the two
machine screws provided with the radio system.
Switch

INSTALLING THE WING STRUT

1. Secure the wing strut.
Battery
Receiver
60
61
80mm
Center
line
Screw
62
Screw
2. Glue the plastic part.
INSTALLING THE PILOT
1. Do not glue the pilot because the pilot must be
remove when changing the battery.
2. Glue the velcro to the pilot and chair
14
CESSNA 182
C.A glue
Glue the velcro
Screw
63
64
65
66