Error And Status Indicate On The Control Panel; Codes On The Screen - Ricoh SP 200s Operating Instructions Manual

8. Troubleshooting

Error and Status Indicate on the Control Panel

Codes on the Screen

• If "C", "c", or "r" appears, contact your sales or service representative.
Code
A paper jam has occurred in the
E0
machine.
E1 Tray 1 has run out of paper.
E3 The front cover or fusing cover is open.
E4 The bypass tray has run out of paper.
An appropriate size paper for printing
E5
Report is not loaded.
The print cartridge has not been
E6
installed.
The paper for ID Card copy is not
E9
loaded.
If paper is loaded in the bypass tray
e2 when printing with the paper fed from
Tray 1, you cannot print.
The specified paper size of the file does
P1 not match that of the paper loaded in
Tray 1.
The specified paper type of the file does
P2 not match that of the paper loaded in
Tray 1.
76
Causes Solutions
Remove the jammed paper. See page 64
"Paper Feed Problems".
Load paper into Tray 1. See page 24
"Loading Paper".
Close the front cover or fusing cover
completely.
Load paper into the bypass tray. See page 24
"Loading Paper".
Load the appropriate size paper.
Reinstall the print cartridge. See page 57
"Replacing the Print Cartridge".
Load the appropriate size paper.
Remove the paper loaded in the bypass tray.
Press the [Start] key to begin printing, or press
the [Stop/Clear] key to cancel the job.
Press the [Start] key to begin printing, or press
the [Stop/Clear] key to cancel the job.