Weld Output Terminals; Connecting To Weld Output Terminals - Miller Bobcat 225 Owner's Manual

5-8. Weld Output Terminals

5-9. Connecting To Weld Output Terminals

1
6
3
4
5
1 2
2
Tools Needed:
3/4 in.
.
A complete Parts List is available at www.MillerWelds.com
!
Stop engine.
!
Failure to properly connect
weld cables may cause exces-
sive heat and start a fire, or
damage your machine.
1 Work Weld Output Terminal
2 Electrode Weld Output Terminal
Connect work cable to Work terminal.
Connect electrode holder cable or
electrode weld cable to Electrode ter-
minal for Stick and MIG welding.
Connect torch cable to Electrode ter-
minal for TIG welding.
Use Process Selector switch to
select type of weld output (see
Section 6-1).
.
See Sections 6-3 thru 6-5 for typi-
cal process connections and
control settings.
!
Stop engine.
!
Failure to properly connect
weld cables may cause ex-
cessive heat and start a fire,
or damage your machine.
.
Do not place anything between
weld cable terminal and copper
bar. Make sure that the sur-
faces of the weld cable terminal
and copper bar are clean.
1 Correct Weld Cable
Connection
2 Incorrect Weld Cable
Connection
3 Weld Output Terminal
4 Supplied Weld Output
Terminal Nut
5 Weld Cable Terminal
6 Copper Bar
Remove supplied nut from weld
output terminal. Slide weld cable
terminal onto weld output terminal
and secure with nut so that weld
cable terminal is tight against cop-
per bar.
803 750-B / Ref. 240 947-A
803 778-B
OM-4434 Page 27