Hangar 9 Tango 40 ARF Assembly Manual page 15


Step 6
Install the propeller and spinner onto the engine.
Consult the instructions provided with your engine
for further details.

Step 7
Remove the access hatch from the bottom of the fuselage.
Section 3A: Two-Stroke Engine Installation

Step 8
Install the throttle servo into the fuselage. Turn on the
radio system and center the throttle stick and trim. Slide
the pushrod into the brass connector. Position the servo
horn onto the servo so the horn is perpendicular to the
servo centerline.

Step 9
Remove the servo horn and attach the pushrod connector
to the throttle servo arm using the connector backplate.
You will need to enlarge the hole in the servo arm using a
5/64-inch (2mm) drill bit.
15