CAUTION
Failure to inspect the air filter fre-
quently if the ATV is used in dusty,
wet, or muddy conditions can dam-
age the engine.
1. Remove the seat; then remove the
clips securing the air filter housing
cover.
2. Loosen the clamp securing the air fil-
ter to the inside of the housing; then
remove the filter.
3. Carefully remove the pre-filter from
the air filter. If the air filter is dirty, it
must be replaced.
4. Using an air hose, clean the pre-filter.
68
5. Slide the pre-filter over the closed end
of the new filter and install into the
housing. Tighten the clamp securely.
6. Install the air filter housing cover and
secure with the clips.
7. Install the seat.
Air Filter Housing Drain
Inspect the drain beneath the main hous-
ing for debris and for proper sealing.
XR002A
Draining V-Belt Cover
NOTE: If the ATV has been driven
through water, the V-belt cover must
be drained of any water.
1. Place the ATV on a level surface.
2. Remove the drain bolt from the cover
and allow the water to drain out.
XR029A
3. Shift the range lever to the neutral
position; then start the engine.
4. Increase and decrease engine RPM
several times to "blow out" any
water; then stop the engine.
5. Install the drain bolt and tighten
XR049
securely.
NOTE: The V-belt and pulleys
should be inspected every 500 miles
and the belt replaced (if necessary).
XR055A
XR014A