Arctic Cat XR 500 Operator's Manual page 54


NOTE: The engine hour meter will
not activate until engine speed
exceeds 500 RPM.

NOTE: An item can only be dis-
played in this position if it is not
already being displayed in the top
display. To set the clock when the
clock is in this position, press and
hold the Middle Button; then use the
procedure found in 4.
6. Coolant Temperature/Battery Volt-
age/Intake
Level Display - Displays coolant tem-
perature, battery voltage, intake air
temperature,
RPM's. Press the Right Button to
change which parameter is being dis-
played. Press and hold the Right But-
ton to see the actual values associated
with the mode selected.
CAUTION
Continued operation with high engine
temperature may result in engine
damage or premature wear.

NOTE: High engine RPM, low vehi-
cle speed, or heavy load can raise
engine temperature.
engine RPM, reducing load, and
selecting an appropriate transmis-
sion gear can lower the temperature.

NOTE: Debris in the engine com-
partment (or packed between the
cooling fins of the radiator) can
reduce cooling capacity. Using a gar-
den hose, wash the radiator and the
engine to remove any debris pre-
venting air flow.
CAUTION
Arctic Cat does not recommend
using a pressure washer to clean the
radiator core. The pressure may bend
or flatten the fins causing restricted
air flow, and electrical components
on the radiator could be damaged.
Use only a garden hose with spray
nozzle at normal tap pressure.
7. Gear Position Indicator - Indicates
which gear is selected.
8. Differential Lock Indicator - Displays
LOCK when the differential lock has
been engaged.
52
Air Temperature/Fuel
fuel quantity,
Decreasing
9. Drive Select Indicator - Displays
4WD when selected by the drive
select switch or when the differential
lock is engaged.
10. Seat Belt Reminder Indicator - Each
time the ignition switch is turned ON,
the indicator will illuminate on the
speedometer for 8-10 seconds to remind
occupants to secure their seat belts.
! WARNING
The seat belt indicator is only a
reminder and automatically extin-
guishes after 8-10 seconds. It does
and
not indicate that seat belts are prop-
erly secured. It is the operator's
responsibility to ensure all vehicle
occupants are properly seated with
seat belts secure and doors are prop-
erly latched. Serious injury or death
could occur as a result of falling out-
side a moving vehicle.
11. EFI Malfunction Indicator - A diag-
nostic code (see list below) and
engine icon will be displayed on the
LCD whenever an EFI error is
detected. The LCD will be normal,
but the code and engine icon will con-
tinue to be displayed on the LCD
until the error is corrected.

NOTE: Take the vehicle to an
authorized Arctic Cat dealer to have
the error corrected and the system
error reset as soon as possible.
WT114A