Assigning a device address
Activating optional
functions (code entry)
Assigning a Device Address
If the MP 1250 R shall be operated in a system with R
it is necessary to assign a device address in the System Configuration menu to
the MP 1250 R.
• Open the menu by a brief press on the
• With the
/
• To change the address first activate this menu item by pressing the
-button, then select the address with / -buttons.
You have the choice of the following device addresses:
CD
Tuner
Aux3
DVD
Please select that device address which corresponds to the amplifier input
the MP 1250 R is connected to. In most cases the AUX1 address will be the
best choice for the MP 1250 R
• After selecting the desired address, please press the
store your selection.
• To leave the menu, please press the
You can leave the menu any time without changing the address assignment by
pressing the
Activating optional functions
The MP 1250 R features the facility to release optional (extra-cost) functions by
entering a four-digit code, such as the reproduction of high-definition music
material at up to 24 bit / 96 kHz.*
This is the procedure for entering the code:
Switch the machine on using the
•
afterwards hold the
Menu" appears.
Use the
button to move the arrow downwards on the screen until
•
the menu point "Code" is selected.
You will now see the message "starting SCL", followed by "- - - -" (or an
•
already activated option; the latter can be overwritten)
Activate the input process by pressing the
•
Enter the first point using the
•
(Optionally using the
•
handset)
Press the
button to move to the next point.
•
Repeat the procedure until you have entered the remaining points.
•
To accept the code you have entered, press the
•
have finished the data entry process.
The screen now displays "starting SCL".
•
When the code has been verified, you will see a message such as "HDA
•
ok" for the release of reproduction of high-definition music material at up to
24 bit / 96 kHz.
*
This function may require a software update
You can obtain the code required for the release process by completing an on-
line form, which you will find on the website (www.taelektroakustik.de) in
the Support area under Hardware / Software. You can also contact us by
telephone on [0049] 5221-76760, or by post.
buttons select the menu item Device Address
Tape1
Tape2
STB
VCR
button.
-button.
-button, and immediately
button pressed in until the "Software Update
/
buttons.
to
buttons on the remote control
or RC control,
LINK
-
button on the front panel.
TV
Aux1
Aux2
AuxAV1
AuxAV2
DBR
-button again to
button.
button when you
31