Table of Contents
Advertisement
Opening the Network
Configuration Menu
Operating the Menu,
Changing and Storing
IP Addresses
Closing the Menu
Interrupting the Menu
without Storing the
Settings
First select the MP 1250 R's Streaming Client function by pressing the
button on the front panel.
Open the configuration menu with a long press on the
front panel. You should now see the configuration menu on the front panel
screen.
Use the
/
buttons in the menu to select the network parameter to
be changed, and activate the entry with the
You can now change the setting using the following buttons, depending on the
type of setting:
/
button
Numeric buttons
to
(remote control only)
Alpha-numeric input
(remote control only)
When the setting process is complete, or when you have entered the complete
address, press the
button to confirm your action.
Alpha-numeric entry (remote control only)
At certain points, e.g. for entering server names or passwords, it is necessary to
input series of characters (strings). At such points you can enter letters, num-
bers and special characters by repeatedly pressing the numeric buttons on the
remote control handset, as when writing SMS news. The assignment of letters to
the buttons is printed below the buttons. Special characters can be accessed
using the
and
. , ? ! : ; \ " ' _ $ % & # ~
Use the blue
button for toggling between numbers, capitals and lower-
case letters. The bottom line of the screen shows which input mode is currently
selected.
At certain points (e.g. DNS server name) it is possible to enter both an alpha-
numeric string and an IP address. At these points an IP address should be
entered like a string (with separating dots as special characters). In this case an
automatic check for valid address ranges (0 ... 255) is not carried out.
Alpha-numerical input without the remote control handset
If you wish to operate the menus without using the remote control handset,
please note that the MP 1250 R can also be controlled directly using the buttons
on the front panel: see the section entitled "Alpha-numerical input using the
front panel buttons"
Once you have correctly set all the parameters, select the menu point 'Save',
then press the
button. This action causes the MP 1250 R to accept the
settings, and the machine restarts with the new network settings. After the
restart you should see the available network media sources (Internet radio,
UPnP-AV server, etc.) displayed in the main menu.
At any time you can leave the network configuration menu without making any
changes to the network settings: this is done by pressing the
which takes you to the menu point 'Exit'. Pressing the
juncture interrupts and closes the menu.
button.
for simple selection (ON / OFF)
for entering IP addresses
for entering text
buttons:
+ - * / ^ = { } ( ) < >
button on the
button,
button at this
25
Advertisement
Table of Contents
