Table of Contents
Advertisement
The Configuration for a Wired Ethernet LAN or Power-Line LAN connection
Setting the Parameters
for a Wired Network
Menu Point
MAC
DHCP
Device IP
IP mask
Gateway
DNS 1
DNS 2
Proxy
Proxy IP
Proxy port
Device Name
Network Mode
Save
Exit
26
• Connect the MP 1250 R to an operational network or Power-Line modem
using the LAN socket on the back panel.
• Switch the MP 1250 R on, and select the Streaming Client function by
pressing the
button on the front panel.
• Call up the Configuration menu as described above. You should now see the
menu reproduced below, displaying the network parameters. In the title line
the message 'LAN' should appear, indicating that the machine is connected to
a wired LAN. If you see 'WLAN' at this point instead, please check your
network connection, and ensure that the network is switched on and
operational.
• You can now select the individual menu points and adjust them to match your
network conditions. The illustration below shows the possible button inputs
after each menu point.
: Switching ON / OFF
/
(0...9):
Numeric input, separating dots are automatically generated;
input limited to valid addresses
(0...9, A...Z):
Alpha-numeric input and special characters.
IP - separating dots must be entered as special characters.
The parameters illustrated above are only typical values.
Addresses and settings may require different values for your network.
Description
The MAC address is a hardware address which uniquely identifies your
machine. The address displayed is determined by the manufacturer, and cannot
be altered.
ON
If your network includes a DHCP server, please select the ON setting at this
point. In this mode an IP address is automatically assigned to the MP 1250 R by
the router. The screen shows only the MAC address and the message DHCP
state ON. In this case the address input fields shown in the illustration do not
appear in the menu.
OFF
If your network does not include a DHCP server, please select the OFF setting.
In this mode you must configure the following network settings manually. Please
ask your network administrator for the addresses to be entered for your network.
IP address of the MP 1250 R
Network mask
IP address of the router
Name / IP of the name server (optional)
Alternative name server (optional)
ON if a proxy server is present, otherwise OFF
Address of the proxy server
Port number of the proxy server
Name of the device which appears in the network
Netwoksetting: only WLAN; or only LAN; or automatic setting
Stores the network parameters, and restarts the MP 1250 R with the new
settings.
Closes the menu: data already entered is discarded.
Possible entries
Advertisement
Table of Contents
