How To Drain; Water Tank; Continuous Drainpipe - Sharp DW-D12A Operation Manual

HOW TO DRAIN

WATER TANK

When the water tank is full, the dehumidifier will stop running
automatically. You need to empty the water tank and put it back into
the main unit. Otherwise, the dehumidifier cannot be restarted.
1
Water tank
groove (right)
2
Uncover the drainage outlet
of the water tank to pour the
water away
3
●
For continuous drainage, remove the rubber plug of water line with your
hands and connect a proper soft plastic pipe to the drainage mouth
through the drainage hole in the rear cover. The water tank will not be
filled with water when the dehumidifier operates continuously. In this
case, the dehumidifier can operate continuously and will not stop due to
protection when the water tank is full of water.
●
During continuous drainage, the drainpipe must be kept flat on the floor.
No part of the drainpipe can be folded or upturned, and the outlet of the
drainpipe cannot go deep under the liquid surface of another container;
otherwise water cannot be drained smoothly or drainage may stop.
●
Always stop the operation and dispose water before moving the main unit.
NOTE
(Water in the tank may spill and damage household goods.)
● Clean the inside of water tank periodically (about once a week).
14
(Failing to clean for a long period of time may increase mold and bacteria which causes bad odor.)
After the water tank is removed, the
Tank full indicator blinks and the
operation stops.
FULL
Beep, beep...
Remove the
●
To prevent water overflow, pull
water tank
the water tank out slowly and
carry it around carefully. Do not
tilt or drop the water tank
Water tank
groove (left)
Pull it out straightly
Empty the
water tank
●
Put the water
Push in the water tank reliably
and properly
tank back into
●
Do not push in the water tank
the unit
rashly (otherwise malfunction
may be caused)
Continuous
drainage
Drainage
hole plug

Continuous drainpipe

CONTINUOUS DRAINPIPE
1
Blinking
2
3
Press with your
right finger
4
Unplug the power plug
Take out the water tank
Water tank
and take off the rubber
cap on the back side
Rubber cap
Tank groove
While pressing the drain stop-
Drain outlet
per with your right finger, run
the hose through the continu-
Drain stopper
ous drainage hole on the back
Continuous
of the main unit and securely
drainage hole
insert into drain outlet.
Insert with your left hand
Make sure the hose is
Recommended specifications of hoses to
be purchased separately: 12 mm (inner inserted all the way in.
diameter); 16 mm (outer diameter).
Set the water tank
to the main unit
Do not use an old
hose with wide
Hose
opening.
(Otherwise, water
may leak.)
15