How To Drain - Sharp Plasmacluster DW-J27FV Operation Manual

HOW TO DRAIN

When the Water Tank
is Full, the TANK FULL
Indicator Light is blinking.
1. Remove the Water Tank.
2.
Dispose the water of the Water Tank.
Drain Outlet
3.
Install the Water Tank.
Drain Outlet
NOTE
• Clean the Water Tank once a week. If you do not
clean the Water Tank, it can cause mold, bacteria,
and bad odors.
♪ ♪･･･
Water Tank
Tank knob
▶
EN-11
When you want to drain continuous
How to pipe the hose
Always have the tip slanted.
Do not bend.
1. Remove the Plug.
2.
Remove the Water Tank and the
Rubber Cap.
Rubber Cap
3.
Set the hose in the Back Hole.
Commercial hose :
inner diameter 15mm
(outer diameter up to
21mm)
4.
Insert the hose firmly to bottom in the
Drain Hole.
Drain Stopper
5. Install the Water Tank.
Under cold weather,
do not put the hose
into the water.
Back Hole
Back Hole
Drain Outlet Hose