Rear Cover Block - Canon EOS D60 Service Manual

NOTE : Assembling
Spring
Ball
(1)
-4
LED window
Insert the tweezers
from inside and
remove it upwards.
Screw
hole
Screw hole Dowel holes

2.17 Rear Cover Block

(1) BUZZER FPC
1. Remove six screws.
2. Remove the FPC holder plate.
3. Remove the washer, connector, and switch from the back cover (quick-control) dial switch block.
4. Remove the access lamp block from the rear cover with the FPC attached to
the LED window.
5. Unsolder the FPC from the buzzer.
6. Remove the BUZZER FPC from the rear cover.
7. Peel off the main dial FPC from the BUZZER FPC.
8. Peel off the adhesive and remove the LED window.
(2) Back cover dial
1. Remove two screws. Remove the washer and connector from the back cover dial block.
2. Remove the back cover dial while taking care not to drop the click spring and ball.
3. Remove the E-ring and remove the SET button.
NOTE : Assembling
When assembling the back cover dial, insert the spring and ball into the dial first.
After assembling, check the click stops as you rotate the dial.
(3) TFT LCD window
1. Remove the TFT LCD window by pushing on it from inside the rear cover.
(3)
-1
With double-sided tape
Be careful Loose
parts.
Coat the face of back cover dial with PL-015
(2)
-2
(1)
(2)
-3
Fix it using
D1663B
(1)
-4
Be careful
Loose
parts.
3.5mm
(2)
-1
Fix it using
D1663B
Fig. 3-23 Rear cover block
3-23
Part 3: Repair Information
-3
(1)
-1
(1)
-3
c 2.5
(1)
mm
-5
x
(1)
-8
(1)
-7
4.0mm ab
Be careful Loose
parts.
Be careful Loose
parts.
(1)
-2
(1)
-6
ab
4.0mm
(1)
-1