Installing Signcut Software - US Cutter Copam User Manual

When asked what port your cutter uses, select the Port that corresponds with your setup. If using a USB
connection you will need to select the COM port that corresponds with your setup (Noted above from the
"Finding Your COM Port" section of the manual).
Make sure that your Baud Rate option is set to 9600.
Do not change the, Data Bits, Stop Bits, or Parity options.
Make sure the Flow Control option is set to "Hardware".
Installing SignCut (and Inkscape*) Software
*If you will be using the SignCut software to cut from your computer you will also need a vector design program.
SignCut is strictly a cutter interface and cannot be used to create signs and designs. The instructions in this manual will
give directions for using Inkscape (A popular free vector design program) with SignCut but directions for other software
will be mostly the same. If you prefer creating vector graphics in Illustrator, CorelDraw, or another vector graphic
design program then you can choose to not install Inkscape and work with your preferred software.
Go to: www.signcutpro.com/bundle.html
Fill out the form and click "Register"
You will be directed to a page where you will be given a download link and a license number. Save this
page or print it for reference. A copy of this page will also be sent to the email address used while filling
out the Registration form.
Follow the link to the web address that corresponds to your operating system and download the SignCut
software installation program.
After the SignCut software installation program has been downloaded, run the program and follow the on
screen instructions.
You will be asked if you would also like to download Inkscape. If you have not already done so and you
would like to use the Inkscape software as a vector design program, select the yes button and the Inkscape
software will be downloaded.
Follow the Inkscape installation instructions. SignCut installation will be temporarily paused.
When you are finished installing Inkscape SignCut will resume installation and finish.
Installation is now complete.
- 15 -