Table of Contents
Advertisement
Error messages
If
("Start/Stop" button) is pressed before the sewing machine is correctly set up or if an operation is
performed incorrectly, an error message appears in the stitch indicator. Follow the instructions that appear.
The message may disappear if the operation is performed correctly. The message will disappear if
(Stitch selection keys) is pressed while the message is displayed.
Error Message
F1~F9
Probable Cause
The "Start/Stop" button or "Reverse/Reinforcement
Stitch" button was pressed while the presser foot was
raised.
A stitch other than the buttonhole or bar tack stitch was
selected and the "Start/Stop" button was pressed while
the buttonhole lever is lowered.
The buttonhole or bar tack stitch was selected and the
"Start/Stop" button was pressed while the buttonhole
lever is raised.
The "Reverse/Reinforcement Stitch" button or "Needle
Position" button was pressed while the bobbin winder is
moved to the right.
The "Start/Stop" button was pressed while the foot
controller was connected.
The motor locked up because the thread is tangled.
The needle mode selection key was pressed while a
stitch that cannot be used with twin needle sewing was
selected.
You tried to select a different stitch while the twin
needle sewing setting was selected (the key is lit).
If error message "F1" through "F9" appears in the LCD
while the sewing machine is being used, the machine
may be malfunctioning. Contact your nearest
authorized service center.
or
Troubleshooting
115
4
Advertisement
Table of Contents
