— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
GETTING READY
CAUTION
●
Be sure to securely tighten the screw
with the screwdriver, otherwise the
needle may touch the presser foot,
causing it to bend or break.
Before starting to sew, slowly turn the
●
handwheel toward you (counterclockwise)
and check that the needle does not touch
the presser foot. If the needle hits the
presser foot, the needle may bend or break.
Note
● When sewing with the walking foot, sew at
a speed between slow and medium.
■ Removing the walking foot
1
Press
("Needle Position" button) once
or twice to raise the needle.
1 "Needle Position" button
The needle is raised.
Turn off the sewing machine.
2
36
1
Raise the presser foot lever.
3
1 Presser foot lever
The presser foot is raised.
4
With a screwdriver, loosen the presser foot
holder screw, and then remove the walking
foot.
1 Presser foot holder screw
Attach the presser foot holder.
5
• For details, refer to "Removing the presser
foot holder" (page 35).
Memo
● Only the straight stitch (with reinforcement
stitching) and the zigzag stitch can be used
with the walking foot. For details on the
stitches, refer to "Stitch Settings" (page 94).
Note
● The optional walking foot is available
through your Brother dealer.
a
a