Installing The Bobbin - Brother 885-U20 Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
GETTING READY

Installing the bobbin

Install the bobbin wound with thread.
CAUTION
●
Use a bobbin that has been correctly
wound with thread, otherwise the needle
may break or the thread tension will be
incorrect.
●
The bobbin was designed specifically for
this sewing machine. If bobbins from
other models are used, the machine will
not operate correctly. Use only the
included bobbin or bobbins of the same
type (part code: SA156, SFB (XA5539-
151)).
Actual size
11.5 mm
(7/16 inch)
This model
Memo
● The order that the bobbin thread should be
passed through the bobbin case is indicated
by marks around the bobbin case. Be sure
to thread the machine as indicated.
1 Press ("Needle Position" button) once or
twice to raise the needle, and then raise the
presser foot lever.
2 Turn off the sewing machine.
3 Slide the bobbin cover latch to the right.
1
1 Bobbin cover
2 Latch
The bobbin cover opens.
20
Other model
2
4 Remove the bobbin cover.
5 Hold the bobbin with your right hand and
hold the end of the thread with your left.
• Be careful not to drop the bobbin.
6 Insert the bobbin with your right hand so that
the end of the thread is on the left, and then,
after pulling the thread firmly around the tab
with your left hand as shown, lightly pull the
thread to guide it through the slit.
1
1 Tab
• Be sure to insert the bobbin correctly.
CAUTION
●
Be sure to install the bobbin so that the
thread unwinds in the correct direction,
otherwise the thread may break or the
thread tension will be incorrect.