Table of Contents
Advertisement
Memo
● The order that the bobbin thread should be
passed through the bobbin case is indicated
by marks around the bobbin case. Be sure
to thread the machine as indicated.
The marks around the bobbin case differ
depending on the model.
7
While lightly holding down bobbin with your
right hand as shown, guide the thread through
the slit (1 and 2).
• At this time, check that the bobbin easily
rotates counterclockwise.
Then, pull the thread toward you to cut it with
the cutter (3).
2
3
1 Slit
2 Cutter (Cut the thread with the cutter.)
1
Note
● Make sure that the thread is correctly
inserted through the tension-adjusting
spring of the bobbin case. If it is not inserted
correctly, reinsert the thread.
1
1 Tension-adjusting spring
8
Reattach the bobbin cover.
Insert the tab in the lower-left corner of the
bobbin cover, and then lightly press down on
the right side.
1
The lower threading is finished.
Next, thread the upper thread. Continue with
the procedure in "Upper Threading" (page 22).
Memo
● You can begin sewing without pulling up
the bobbin thread. If you wish to pull up the
bobbin thread before starting to sew, pull
up the thread according to the procedure in
"Pulling up the bobbin thread" (page 29).
Winding/Installing the Bobbin
1
2
21
Advertisement
Table of Contents
