Installing The Hard Disk; Using The Ram Disk - Kyocera Mita S-9100DN Operation Manual

Chapter 2 Setting the Defaults

2.1.5 Installing the Hard Disk

Check that the optional hard disk is installed in the printer correct-
ly.
1
Browse Start > Settings > Printers.
2
Right click on the Kyocera Mita FS-9100DN KX or
Kyocera Mita FS-9500DN KX icon and then click Prop-
erties.
The Properties dialog box is displayed.
3
Click the Device Settings tab.
4
Check Hard Disk in the Device Options list box.
NOTE
When installing hard disk, make sure to remove the
check mark of the RAM Disk.
5
Click the OK button.
2-5

2.1.6 Using the RAM Disk

Turn the RAM disk mode On and set its size using the printer's
operator panel beforehand.
1
Browse Start > Settings > Printers.
2
Right click on the Kyocera Mita FS-9100DN KX or
Kyocera Mita FS-9500DN KX icon and then click Prop-
erties.
The Properties dialog box is displayed.
3
Click the Device Settings tab.
4
Check RAM Disk in the Device Options list box.
NOTE
When using RAM disk, make sure to remove the check
mark of the Hard Disk.