Using The Document Finisher (Df-70/Df-71) - Kyocera Mita S-9100DN Operation Manual

Chapter 3 Printing Through Application Software
3.4 Using the Document Finisher
(DF-70/DF-71)
DF-70 provides the staple function, while DF-71 provides the
punch function.
1
Browse File > Print. The Print dialog box will be dis-
played.
3
2
Click on the Name drop down list, all the printers in-
stalled under Windows are listed. Select Kyocera Mita
FS-9100DN KX or Kyocera Mita FS-9500DN KX.
3
Select the range of the pages you want to print in the
document, All or Page range. To print part of the docu-
ment, check Pages, then enter page numbers separat-
ed by commas.
4
Specify the number of copies you want to print in the
Number of copies combo box in Copies.
5
Click the Properties button in the Print dialog box. The
Properties dialog box is displayed.
6
Click the Output tab.
7
Select Finisher [Face-down] or Finisher [Face-up]
as Output to drop down list, and click the OK button.
3-7
8
If you want to collate the output pages, check the
Collate box.
2
4
Finishing Options
Collate:
Reverse
Page Order: prints in the reverse page order.
Staple:
Offset:
Punch:
9
Click the OK button in the Properties dialog box. The
Print dialog box is displayed again.
10
Click the OK button to start printing.
sets whether the pages are collated or
not.
selects the staple position: Upper Left,
Upper Right or Booklet (stitching posi-
tion).
Outputs pages while shifting them alter-
nately for each document.
selects the hole punch type: 2-Hole, 3-
Hole or 4-Hole.