Baud Rate - Kyocera Mita S-9100DN Operation Manual

Chapter 3 Using the Operator Panel
7
Press the 3 or 4 key to display the desired mode. The
display changes as shown below. Press the ENTER
key.
Nibble (high) (default)
AUTO
Normal
High speed
8
Press the MENU key. The message display returns to
Ready.
Q Q Q Q Changing Serial Interface Modes
You can set the baud rate, data bits, stop bits, parity, and proto-
col for the serial interface.
1
Press the MENU key.
2 Press the 3 or 4 key repeatedly until Interface >
appears. One of the interface names shown below ap-
pears, indicating the current interface.
Parallel (default)
Serial
Network
(only when an optional network interface
Option
card is installed)
3
Press the ENTER key. A blinking question mark (?) ap-
pears.
Interface
?Parallel
4 Press the 3 or 4 key repeatedly until Serial ap-
pears.
Interface
?Serial
5
Press the ENTER key again.
3-19
6
Press the 2 key. Each time the 3 or 4 key is pressed,
the setting item and current setting change as shown
below.
>Baud Rate
9600
>Data Bits
8
>Stop Bits
1
>Parity
None
>Protocol
DTR(pos.)&XON
>Barcode Mode
Off
7
Display the setting item to be changed and press the
ENTER key. A question mark (?) appears.
The following example explains how to change the
baud rate. The settings for other items can be changed
in a similar manner.
>Baud Rate
? 9600
8 Press the 3 or 4 key to display the desired setting.
The baud rate can be selected from 1200, 2400, 4800,
9600 (default), 19200, 38400, 57600, and 115200.
NOTE
Some computers may not be compatible with a baud
rate of 115200 bps. If you set the baud rate to 115200
and communication problems occur, lower the baud
rate.
Definable baud rates:
1200, 2400, 4800, 9600
(default), 19200,
38400,57600, 115200
Definable stop bits: 7, 8
(default)
Definable data bits: 1 (de-
fault), 2
Definable parity: None
(default), Odd, Even, Ig-
nore
Definable protocol: DTR
(pos.) & XON (default),
DTP (positive), DTR (neg-
ative), XON/XOFF, ETX/
ACK
If set to On when the option
barcode reader is installed,
the mode of the serial inter-
face will be the barcode
mode.